Design principles: advanced, reliable, efficient, and practical

Overall design and optimization: including factory layout, compressed air, power supply and distribution, water supply and drainage, chlorine water recovery and circulation, thermal oil system, steam system, etc

Design direction: Two handed mold design, three handed mold design, eliminating single handed molds

The characteristics of the new generation of rubber glove production line:

1. High speed: fast speed, stable operation, and few accidents

Nitrile dual-mode line speed of 38-45 meters/min, chain pitch of 100,38 meters=760 pieces/min

Nitrile the third mock examination linear speed 35-40 m/min, chain pitch 100,35 m=1050 pieces/min

Reduce production line downtime and improve production line capacity utilization;

The chain runs at high speed and stability, and the sprocket is not easily offset;

Reduce oil stains on chain tracks, chains, mold seats, curved rails, and pressure rails.

2. Intelligence: automatic adjustment of production processes, automatic warning

3. Automation: Collaborate with automation equipment factories to make automation equipment smarter and smoother

4. Energy saving and environmental protection: energy-saving, water-saving, and energy storage equipment.

Significantly reduce the overflow of heat energy from the oven and improve the conversion rate of heat energy.

The production line is recycled and the cleaning frequency of the glue tank is low.

5. The glove has a low defect rate, sufficient vulcanization, and good curled edges.