Design principles: advanced, reliable, efficient, and practical

Overall design and optimization: including factory layout, compressed air, power supply and distribution, water supply and drainage, chlorine water recovery and circulation, thermal oil system, steam system, etc

Design direction: Two handed mold design, three handed mold design, eliminating single handed molds

Characteristics of the new generation latex glove production line:

1. High speed: fast speed, stable operation, and few accidents

Latex dual-mode inspection hand line speed of 30-35 meters/min, chain pitch of 100,30 meters=600 pieces/min

The linear speed of latex the third mock examination inspection hand is 30-35 m/min, and the chain pitch is 100,30 m=900 pieces/min

Latex dual-mode medical hand wire speed of 22-25 meters/min, chain pitch of 100,22 meters=440 pieces/min

Latex the third mock examination doctor's hand linear speed 20-23 m/min, chain pitch 100,20 m=600 pieces/min

Reduce production line downtime and improve production line capacity utilization;

The chain runs at high speed and stability, and the sprocket is not easily offset;

Reduce oil stains on chain tracks, chains, mold seats, curved rails, and pressure rails.

2. Intelligence: automatic adjustment of production processes, automatic warning

3. Automation: Collaborate with automation equipment factories to make automation equipment smarter and smoother

4. Energy saving and environmental protection: energy-saving, water-saving, and energy storage equipment.

Significantly reduce the overflow of heat energy from the oven and improve the conversion rate of heat energy.

The production line is recycled and the cleaning frequency of the glue tank is low.

5. The defective rate of gloves is low, the vulcanization is sufficient, the gloves do not stick, and the edges are well rolled.